ROTACORE / BEARING CALCULATIONS

How to calculate bearing L10 life

Equivalent load, basic rating life in revolutions and hours, reliability factors and a worked example.

What L10 means

L10 is the life that 90 % of a group of identical bearings will reach or exceed before the first sign of rolling contact fatigue. It is a statistical design life, not a guarantee for one bearing, and it assumes good lubrication and cleanliness.

Step 1: equivalent dynamic load P

P = X · Fr + Y · Fa

Fr is the radial load and Fa the axial load. X and Y come from the bearing maker’s catalogue and depend on the bearing type and on Fa/Fr. With no axial load, P = Fr.

Step 2: basic rating life

L10 = (C / P)p   million revolutions

L10h = 106 / (60 · n) × (C / P)p   hours

C is the basic dynamic load rating from the catalogue, n the speed in r/min, and p = 3 for ball bearings or 10/3 for roller bearings.

Worked example (invented numbers)

A ball bearing with C = 65 kN carries a pure radial load of 5 kN at 1,480 r/min.

StepCalculationResult
Equivalent loadFa = 0, so P = Fr5 kN
Load ratio65 / 513
L1013³2,197 million rev
L10h2,197 × 106 / (60 × 1,480)24,741 h (about 2.8 years running continuously)

Higher reliability

For a reliability above 90 %, multiply by the life adjustment factor a1:

Reliability90 %95 %96 %97 %98 %99 %
a110.640.550.470.370.25

In the example, 99 % reliability gives 0.25 × 24,741 = 6,185 h.

Beyond L10: lubrication and contamination

ISO 281 also gives a modified rating life, Lnm = a1 · aISO · L10. The factor aISO accounts for the lubricant film (viscosity ratio κ), contamination and the fatigue load limit, and can raise or sharply cut the life. A dirty or under-lubricated bearing can fail long before its L10.

Do it in RotaCore

RotaCore works from the machine loads to each bearing position: equivalent load, L10h, reliability, static safety s0, κ and relubrication, with the formula and source shown for every result.

RotaCore overview · ISO 281 in MechAtlas ↗

Sources: ZKL: bearing size selection (basic rating life, equivalent load, a1) · ISO 281 status in MechAtlas. Worked examples use invented numbers. Results are engineering aids; check them against the maker's data and the governing standard.

Calculate both bearings of a shaft

RotaCore splits the machine loads to each bearing and reports L10h, s0, κ and relubrication together.